The Steel Guitar Forum

I have an Alesis Quadraverb. PM me if interested.

Basic harmony singing parts form major or minor chords. Chords are formed from stack of major 3rd, minor 3rd, and perfect 4th. C major is major 3rd (C-E), minor 3rd (E-G) and 5th (G-C). C minor is minor 34d, major 3rd, and 4th. Harmony below the melody will be the major 3rd, minor 3rd, or 4th interv...

Haven't done it in a while, but I've sent amps overseas to various countries using IPSparcel.com THey consolidate shippments using FedEx and other companies. They were always much less cost than using FedEx or any other carrier, but always delivered.

PEC

I have a 1991 Session 400 Wedge without speaker. Can sell head only or with reverb tank but no head cabinet. Amp works fine.
Raybob
5307216513

Yes, rewire the pot so hot stays connected. Use one leg of pot connected to hot, center leg through cap to ground. Try different value caps, probably .1mF would do.

Interested in trade for '33 Dobro F holes, round neck but has raised bone nut and saddles for playing lap style? Also has McIntire feather pickup installed with end pin jack.

It's a lot of work but you can shift your pedals to the right to add pedal to left of E9 pedals and put the C6 P4 change there. Then stepping on that pedal along with 1st "E9" pedal will give the change that your current P7 gives, the five chord. Either eliminate your P7 or move the F# cha...

Power it up on a Variac slowly bringing up voltage to 120 will reform old caps.

Playing Pedal Steel more dates in South Lake Tahoe, CA Wed July 19 7-10 Jeff Connor duo @ Steamer's Bar and Grill, Lake Tahoe Bl Thursday July 27, 6-10: Whiskey & Wolves trio @Artemis on the Lake Ski Run BL. Sunday July 23 1-5: Cash Only Band @ The Beacon Camp Richardson Saturday July 29 1-5: Ca...

ttt

Use a bigger capacitor like a 0.1mF

ttt

My experience tells me that those types of noises can come from other places, too. Cold solder joints, bad small caps (not the power supply ones), or even a bad resistor. And don't forget to clean all the Molex connectors. ;-) I concur. Bad filter caps, if the amp works at all, usually sounds more ...

ttt

6.9v is within the plus/minus 20%. Good.
For bias adjusting, shoot for 70 percent plate dissipation.
https://www.tedweber.com/bias-calc/

Fender schematics have note votlages are + or - 20 percent. You are fine.

ttt

Prices?

ttt

I use volume pedal and reverb on the amp.

Paul Strojan wrote: Is there a way to boost the output of the volume pedal back up to the raw output of the guitar?

Bypass the pedal for full output. The purpose of using a volume pedal is to cut the raw output.

www.tubesandmore.com/

If not there, try https://www.mouser.com/