I have a lap steel with a single volume control. I always run the volume full on and use my volume pedal to control the volume. But I do like an on board tone control for doo wahs and Jerry Byrd effects.
Is it possible to convert the volume control into a tone control by wiring a cap between the lugs?
Single tone control?
Moderator: Shoshanah Marohn
- Tim Whitlock
- Posts: 1768
- Joined: 3 Jan 2001 1:01 am
- Location: Colorado, USA
- Raybob Bowman
- Posts: 273
- Joined: 10 Jan 2006 1:01 am
- Location: S. Lake Tahoe, CA, USA
Yes, rewire the pot so hot stays connected. Use one leg of pot connected to hot, center leg through cap to ground. Try different value caps, probably .1mF would do.
Last edited by Raybob Bowman on 7 Aug 2023 9:33 am, edited 1 time in total.
Sierra U12 4+5 / 1933 Dobro / homemade Tele B-bender
- Jack Hanson
- Posts: 5024
- Joined: 19 Jun 2012 3:42 pm
- Location: San Luis Valley, USA
As an alternative you could install a dual concentric pot for both tone and volume controls. I've done it on a coupla Carolyn Wonderland model Kalamazoos with excellent results:
https://www.youtube.com/watch?v=bsVMfARmqaI
https://www.youtube.com/watch?v=bsVMfARmqaI