I Need A Fuse Holder Assembly 1977 Peavey LTD Steel Amp

[W. C. Edgar]

One that will fit in the hole and will not stick out past the back of the amp and get knocked off again
Don't tell me to search it on the internet as someone has to have the correct one out there even if I have to upgrade to the screwdriver slot type
Thanks
WC

[Bill A. Moore]

You need to know the size you need.
https://www.tubesandmore.com/products/a ... 16c276a974

[W. C. Edgar]

LOL Yep I know
It's a 3AG Type and 6 Amp fuse
Problem is, none of the manufacturers show the total legnth
Thanks

[Bill A. Moore]

Open up the fuses listed, and open measurements and specs, length is there!
(There are also "pictures" with the dimensions!)

[Ken Fox]

https://www.tubesandmore.com/products/amplifier_parts_0

[W. C. Edgar]

The first one listed is too long
Inside of chassis I only have 1 1/2" to work with

[Ken Fox]

https://www.tubesandmore.com/products/f ... r-3ag-type

-40°C to 85°C.
Body Length 1.0 in.
Cap Length 0.78 in.
Chassis Hole Diameter 0.5 in.
Compatible Fuses 3AG
Dielectric Strength ≥ 2,400 V
Electrical Rating 250 V, 20 A
Item Diameter 0.69 in.

[W. C. Edgar]

Thanks, everybody
I got one from Roger at Peavey
If you need one go to them
I upgraded to the screwdriver slot type and it only sticks out about 1/8" on the back and leaves plenty of room inside the chassis to solder the two wires.
peavey does it again.