Sierra steel part

Don Cain · Post by **Don Cain** » 5 Nov 2004 10:29 am

I need one tuning finger for my Crown Sierra.
Tom has a new one but it is a little different and would not match the other 9. The problem is, his new one the string goes over a groove and on mine the string goes through a hole. My question is does anyone have a used finger I can buy. The problem with mine is the screw stripped out and I had to put the next size larger screw in it and I would like to replace the finger. Thanks for any help. Don

Jim Palenscar · Post by **Jim Palenscar** » 5 Nov 2004 1:23 pm

I'll send you one- just give me your name and address~

Bobby Lee · Post by **Bobby Lee** » 5 Nov 2004 10:29 pm

The string goes through a hole? That doesn't sound right. I had a Sierra Crown keyless and the string didn't go through any hole.

Rainer Hackstaette · Post by **Rainer Hackstaette** » 6 Nov 2004 2:41 am

Bobby, Don is talking about the tuning finger on the gearless head behind the roller nut, not the changer finger. I have both, Crown and Session, and on the Crown there is a hole in the tuning finger where the string passes through before it is locked down with an Allen screw and then tuned with a 3/16" hex screw. On the Session, there is a groove instead of the hole and the tuning screw has a plastic "finger tip" top.

Rainer

------------------
<FONT SIZE=1 COLOR="#0000FF">Remington D-10 8+7, Sierra Crown D-10 gearless 8+8, Sierra Session S-14 gearless 8+5, '77 Emmons D-10 8+4, '70 Emmons D-10 8+4, '69 Emmons S-10 6+5, Fender Artist D-10 8+4, Peavey Session 400 LTD, Peavey Vegas 400, Line 6 Variax 700</FONT>