How to build a leg attachment for stomp box pedal?

Bill Ford · Post by **Bill Ford** » 1 Dec 2007 7:32 am

Here's on I made...1/2"PVC, If you can find what is called a "snap T", get those. I used a regular T, have to cut just enough so it will snap onto the leg, also grind/remove the center part that keeps the pipe from going too far into the T(arrow),velcro to hold in place, about $2. It fit tight enough, no glue was needed, let's you adjust for better viewing.

Billy Sims · Post by **Billy Sims** » 28 May 2014 4:27 pm

I saw what Mr. Ford did and so I ran down to the local hardware and built me one a mount like his. Works great! Thanks Bill Ford!

Richard Sinkler · Post by **Richard Sinkler** » 28 May 2014 6:29 pm

I have a Tech 21 Roto choir that I drilled a hole in the bottom plate, glued a T-not to go through the plate (after removing the spikes that hold the T-nut into a piece of wood. I use the mount that came with my StroboFlip tuner to fix it to my guitar leg. I also use an EQ for dobro simulation that I super glued on of those George L leg clamps to the back, and clip it to another leg. They work great.

Jimmy Gibson · Post by **Jimmy Gibson** » 28 May 2014 11:41 pm

This is what I use, works great. And will fit most steel legs.

Jimmy

Bill Ford · Post by **Bill Ford** » 29 May 2014 5:03 am

My latest effort, same cross "T"/snap "T" configuration, 1/8" lexan for base. BF

Joe Naylor · Post by **Joe Naylor** » 29 May 2014 8:04 am

not a leg attachment or a single effects but take a look at this alternative

Joe Naylor
www.steelseat.com

Bill Ford · Post by **Bill Ford** » 29 May 2014 9:05 am

Joe, Maybe something like that as a sidecar for your seats, neat,and compact....Bill

Maybe with wheels, and a slide handle

Larry Behm · Post by **Larry Behm** » 29 May 2014 10:31 am

Something like this would work.

Larry Behm

The Steel Guitar Forum

How to build a leg attachment for stomp box pedal?

Thank you Bill Ford

steelseat.com