| Author |
Topic: help with a profex 2 |
Lyle Bradford
From:
Gilbert WV USA (deceased)
|
Posted 27 Jul 2000 8:20 pm |
|
| I have a profex 2 and when i plugged it up i got this messeage DSP INTERFACE ERROR (resetting system) I reinitialized it then it worked for a couple of minutes. then on settings 119.120,124 it gave the message PARAM OUT OF RANGE (autocorrecting) Is there anyting i can do to correct this or does it need to go to a Peavey workshop? |
|
|
|
Jack Stoner
From:
Kansas City, MO
|
Posted 28 Jul 2000 2:02 am
|
|
Lyle, when you "reinitialized" the unit did you do a "factory reset". If not, do a factory reset as it seems to clear up a lot of flakey problems. If that doesn't do it, it's probably back to Peavey for service.
|
|
|
|
Mike Brown
From:
Meridian, Mississippi USA
|
Posted 28 Jul 2000 5:36 am
|
|
| Let me know when to expect here at the factory. My phone number is 1-877-732-8391(toll free). I'll be glad to assist. Thanks. |
|
|
|
Brinton Payne
From:
Fort Worth, Texas, USA
|
Posted 30 Jul 2004 3:41 pm
|
|
I have the same problem. My settings had weird letters thrown in the middle like Stl St3el. I reset to factory settings. I hadn't turned the Profex on in a few months, can that kill the battery? Can a non-techie replace the battery - I would like to fix all problems before re-loading the settings.
Thanks |
|
|
|
David Higginbotham
From:
Lake Charles, Louisiana, USA
|
Posted 30 Jul 2004 6:15 pm
|
|
The profex 2 will give messages of "dsp interface error" and "bypassed" if the internal memory battery is bad. It will also show default messages such as re- ititializing. Although these messages aren't strictly limited to a battery problem, it is the most likely problem to occur. As far as changing the battery, it is not that difficult to do if you are familiar with using a soldering iron and some experience with electronics. I have changes many and it takes less than an hour. Peavey sells the batteries at $14.02 shipping included or you can locate an electronics dealer and they will likely have it for less than $10.
However, I wouldn't be acknowledging Mike Brown at Peavey and thier fine staff of techs without saying they can likely fix any problem with the unit and at a very reasonable rate!
Dave |
|
|
|
