Nashville 112
-
- Posts: 105
- Joined: 14 Feb 2001 1:01 am
- Location: Cedar City, Utah USA
Nashville 112
I just bought a used NV 112 form a forum member, got it yesterday and plugged it in and turned it on and have a big 'buzz' any ideas ?
-
- Posts: 14
- Joined: 2 Jan 2017 12:51 pm
- Location: Washington, Central calif Friday Harbor Wa.USA
Consider reaching out to Ken Fox
He is the Peavey GURU in my opinion.
Hope he can get you up and running.
Best of luck, Kevin
He is the Peavey GURU in my opinion.
Hope he can get you up and running.
Best of luck, Kevin
Gfi ultra, Hilton pedal,Nashville 112 , Nashville 400,Bakers dozen of accoustic and electric guitars
Peavey Nashville 400
Peavey Nashville 112
Fender Acoustasonic 30
Marshall Jvm410 H
Fender Bassman
Peavey Nashville 400
Peavey Nashville 112
Fender Acoustasonic 30
Marshall Jvm410 H
Fender Bassman
- Bill Ferguson
- Posts: 5692
- Joined: 4 Aug 1998 11:00 pm
- Location: Milton, FL USA
- Contact:
Probably a cold solder joint. Turn the reverb off and hit the top of the amp a few times and see if it goes away.
Also, try a patch cable between the preamp out and power amp in on the back of the amp.
These are the 2 most common problems with this amp.
If neither work, I suggest a Peavey repair person. Ken is great, although he stays very busy.
Good luck
Also, try a patch cable between the preamp out and power amp in on the back of the amp.
These are the 2 most common problems with this amp.
If neither work, I suggest a Peavey repair person. Ken is great, although he stays very busy.
Good luck
AUTHORIZED George L's, Goodrich, Telonics and Peavey Dealer: I have 2 steels and several amps. My current rig of choice is 1993 Emmons LeGrande w/ 108 pups (Jack Strayhorn built for me), Goodrich OMNI Volume Pedal, George L's cables, Goodrich Baby Bloomer and Peavey Nashville 112. Can't get much sweeter.
-
- Posts: 2136
- Joined: 11 Jul 2001 12:01 am
- Location: New Orleans, LA, USA
PV issues
I’d take Bills advice about the patch cable.
Ken has requested no PMs for Peavey tech advice.
Ken’s been extremely generous with the steel community the past few decades,
And knows his stuff. I think we all appreciate Ken’s many contributions.
Hes busy, but has his own shop . You might inquire about having him address your service needs. He’s worked on my Peavey gear in the past , and it was money well spent.
He does great work !!
Ken has requested no PMs for Peavey tech advice.
Ken’s been extremely generous with the steel community the past few decades,
And knows his stuff. I think we all appreciate Ken’s many contributions.
Hes busy, but has his own shop . You might inquire about having him address your service needs. He’s worked on my Peavey gear in the past , and it was money well spent.
He does great work !!