Page 1 of 1
Zum Parts (close it up, found my parts)
Posted: 19 Jan 2019 7:49 am
by David Decker
Needing 3 Zum bell cranks like the ones in the picture. Also changer rods to fit with these bell cranks. Need 1 rod about 7 or 8 inches. 2 about 14" or abouts there. I can cut and shorten and rethread them where needed.
Posted: 21 Jan 2019 6:32 am
by Tim Mathews
Call Bruce Zumsteg (816) 380-4568.
He can send the precut rods and bell cranks complete with tuning nuts
Posted: 21 Jan 2019 3:21 pm
by Paddy Long
I don't think Bruce has had those older comb type bell cranks for several years.
The newer side-attach variety will fit any of the older Zums though.
Posted: 22 Jan 2019 1:39 pm
by Jerry Roller
David, I have these three only bellcranks and I make the rods for them with the 1/16†roll pin in the bellcrank end. I would make them slightly longer and you could cut to size and thread them. I have some nylon tuners but not sure they would be right length.
Please email me at
rollermusic@cox.net if you would like my help.
Thanks, Jerry
