Zum Parts (close it up, found my parts)
-
David Decker
- Posts: 1254
- Joined: 10 Dec 2001 1:01 am
- Location: Canton, Ohio, USA
Zum Parts (close it up, found my parts)
Needing 3 Zum bell cranks like the ones in the picture. Also changer rods to fit with these bell cranks. Need 1 rod about 7 or 8 inches. 2 about 14" or abouts there. I can cut and shorten and rethread them where needed.
Last edited by David Decker on 24 Jan 2019 3:17 pm, edited 1 time in total.
-
Tim Mathews
- Posts: 18
- Joined: 10 Oct 2017 12:52 pm
- Location: Missouri, USA
-
Paddy Long
- Posts: 5462
- Joined: 19 Aug 2003 12:01 am
- Location: Christchurch, New Zealand
I don't think Bruce has had those older comb type bell cranks for several years.
The newer side-attach variety will fit any of the older Zums though.
The newer side-attach variety will fit any of the older Zums though.
14'Zumsteel Hybrid D10 9+9
08'Zumsteel Hybrid D10 9+9
94' Franklin Stereo D10 9+8
Telonics, Peterson, Steelers Choice, Benado, Lexicon, Red Dirt Cases.
08'Zumsteel Hybrid D10 9+9
94' Franklin Stereo D10 9+8
Telonics, Peterson, Steelers Choice, Benado, Lexicon, Red Dirt Cases.
-
Jerry Roller
- Posts: 10319
- Joined: 17 Apr 1999 12:01 am
- Location: Van Buren, Arkansas USA
- Contact:
David, I have these three only bellcranks and I make the rods for them with the 1/16†roll pin in the bellcrank end. I would make them slightly longer and you could cut to size and thread them. I have some nylon tuners but not sure they would be right length.
Please email me at rollermusic@cox.net if you would like my help.
Thanks, Jerry
Please email me at rollermusic@cox.net if you would like my help.
Thanks, Jerry