Big Tuning Wrenches - NOW IN STOCK!!!

Michael Yahl · Post by **Michael Yahl** » 30 Dec 2012 9:19 pm

OK guys, finally got them done and loaded into my website.

The BIG Tuning Wrench is the improved version of Carl Williams wrench. When he announced that he was no longer going to make them I approached him about taking it over. He was pleased, to say the least, that I would like to do that.

I've just finished up a run of wrenches in both the standard 3/16" hex and also a 5mm hex for those guitars that have the shorter tuning nuts. The shorter nuts have a tendency to swell slightly as they're threaded onto the rod. There are also some builders that use a 5mm hex nut. The 5mm wrenches should allieviate the problem of a standard 3/16" hex being tight or not going on at all.

I have marked all of my 5mm wrenches with a double groove filled with red paint to differenciate them from the standard 3/16" hex.

This link will take you to my web page where you can order the wrenches.

http://www.psgparts.com/Wrench-Tuning-P ... TL-GEN.htm

I've tried to keep the same price point on the Big Wrench that Carl had.

Thank you all for your continued support.

Michael Yahl · Post by **Michael Yahl** » 5 Jan 2013 9:49 am

I'll have these at the Phoenix Show.

Roger Shackelton · Post by **Roger Shackelton** » 5 Jan 2013 11:17 pm

HELLO MICHAEL,

I would like to order a BIG WRENCH by postal mail. Please send me your postal mailing address.

ROGER

Michael Yahl · Post by **Michael Yahl** » 6 Jan 2013 6:57 am

Roger,

All of my products are available for purchase from my website. It takes VISA, Mastercard, and Discover.

www.psgparts.com

Here's the link for wrenches
http://www.psgparts.com/Wrench-Tuning-P ... TL-GEN.htm

If an item doesn't show up in the pull down menu selection, then I'm currently out of stock on that item.

I currently offer 14 different wrench configurations.

I'll be back filling the wrench inventory this week and adding a few more new ones.