Adding pulls to a Magnum?

Niklas Widen · Post by **Niklas Widen** » 16 Apr 2009 8:26 am

I've been looking at the Magnum guitars and there are a few things I'd like to know about them.

Are the pull rods, bellcranks etc. used on the Magnum identical to those used on Carters? Would it be possible to use Carter parts to add extra pulls to the Magnum's knee levers? Is it possible to add extra pedals?

Also, are the cabinet dimensions the same as the Carters'? Would a Magnum SD-10 fit in a Carter D-10 fligh case?

/Nicke W

Bill Moore · Post by **Bill Moore** » 16 Apr 2009 9:17 am

The parts are not the same, but they look interchangeable to me. The crossshaft looks the same, so you could mix bellcranks from either guitar. The Magnum has a single blade bellcrank, with holes. The rods are bent 90 degrees to fit into the holes. They use a spring retainer. It's actually simpler and easier to change pulls on the magnum. The pedals look the same to me.

John Fabian · Post by **John Fabian** » 16 Apr 2009 9:29 am

The cross shafts are different sizes. 3/8" vs 5/16 on the Magnum.
You should order Magnum parts for your Magnum.
Carter flight cases will fit the Magnum.

Jim Harper · Post by **Jim Harper** » 22 Apr 2009 10:08 am

I just got me a new Magnum and you can,t believe the sustain this guitar has. It is a great guitar and stay,s in tune. Easy to change copedant,s.I think i changed every pull on the C6th neck. it had 8-8 and a great guitar. I will try to help any one that is interested in one==Jim Harper

Ben Turner · Post by **Ben Turner** » 22 Apr 2009 11:39 am

I owned a Magnum for several months. I was very impressed with the guitar overall. It had a real good sound too!

Al Marcus · Post by **Al Marcus** » 22 Apr 2009 5:46 pm

The magnum looks like a nice lightweight guitar like the Carter. I like the bellcranks and undercarrige of them , eaiser to change a pedal pull. I like that...al.

:)