Need Legs for A Fender DeLuxe (Stringmaster Style)
Moderator: Brad Bechtel
-
Mark Helm
- Posts: 1385
- Joined: 20 Nov 2016 8:52 am
- Location: Tennessee, USA
- Contact:
Need Legs for A Fender DeLuxe (Stringmaster Style)
Anyone know where I can get a set of 3, adjustable?
Remington Steelmaster S8 w/ custom Steeltronics pickup. Vox MV-50 amplifier + an 1940's Oahu cab w/ 8" American Vintage speaker. J. Mascis Fender Squire Jazzmaster, Hofner Club bass, Ibanez AVN4-VMS Artwood Vintage Series Concert Size Acoustic Guitar. 1920s/30s Supertone Hawaiian-themed parlor guitar. Silvertone parlor guitar.
-
Nathan Golub
- Posts: 393
- Joined: 7 Aug 2006 12:01 am
- Location: Durham, NC
-
Tim Whitlock
- Posts: 1944
- Joined: 3 Jan 2001 1:01 am
- Location: Colorado, USA
I bought a set of three of the Sill Music legs for my '51 Custom. Really good quality, but a couple of things to note.
They are Fender Rhodes replacement legs. Fully collapsed they are about an inch longer than fully collapsed OEM Fender steel guitar legs. My Custom sits up a little higher than I would like, but not too bad.
Secondly, the threads on the Sill legs are 3/4". They fit in my Custom just fine but are too big for my '56 Stringmaster. Make sure your guitar will accept a 3/4" thread.
They are Fender Rhodes replacement legs. Fully collapsed they are about an inch longer than fully collapsed OEM Fender steel guitar legs. My Custom sits up a little higher than I would like, but not too bad.
Secondly, the threads on the Sill legs are 3/4". They fit in my Custom just fine but are too big for my '56 Stringmaster. Make sure your guitar will accept a 3/4" thread.
-
Eric Dahlhoff
- Posts: 936
- Joined: 25 Jan 2010 1:04 pm
- Location: Point Arena, California
Legs
I have a set of ZB Custom legs, which have the 3/4" threads. They did fit my old Fender Deluxe.
If you need the 3/4" size send me an email.
If you need the 3/4" size send me an email.
"To live outside the law you must be honest." (Bob Dylan)