Dekley Bellcrank(s) ?
- Scott Denniston
- Posts: 855
- Joined: 19 Jan 2004 1:01 am
- Location: Hahns Peak, Colorado, USA
Dekley Bellcrank(s) ?
I'm looking for a Dekley Bellcrank or two. I understand the older MSA had pretty much the same so that would probably work too.
- Wayne Brown
- Posts: 1793
- Joined: 3 Apr 2002 1:01 am
- Location: Bassano, Alberta, Canada
- Contact:
steel guitar parts
do you have a picture of one. I have some that i don't know what there for.
thanks
wayne
thanks
wayne
Owner Out West Seats,Cases
www.outwestcountry.ca
www.outwestcountry.ca
- Scott Denniston
- Posts: 855
- Joined: 19 Jan 2004 1:01 am
- Location: Hahns Peak, Colorado, USA
I don't have a photo here. The Dekley Bellcranks are usually black. The crossbar hole is round and there are usually 4 pull holes I believe. The pull holes are double (the rod goes between them) and a bushing type thing slides through them and the rod is held in the bushing with a set screw. The MSA is the same but aluminum not black. If you post a photo I could probably tell if your's are one of these.
- Wayne Brown
- Posts: 1793
- Joined: 3 Apr 2002 1:01 am
- Location: Bassano, Alberta, Canada
- Contact:
Steel guitar parts
I’m sorry, thanks for your time
Wayne
Wayne
Owner Out West Seats,Cases
www.outwestcountry.ca
www.outwestcountry.ca
- Scott Denniston
- Posts: 855
- Joined: 19 Jan 2004 1:01 am
- Location: Hahns Peak, Colorado, USA
Thanks for the reply Wayne. Just in case--I found a photo of the MSA bellcranks. It's on a previous for sale post here >>> https://bb.steelguitarforum.com/viewtopic.php?t=386299
- Wayne Brown
- Posts: 1793
- Joined: 3 Apr 2002 1:01 am
- Location: Bassano, Alberta, Canada
- Contact:
steel guitar parts
If those are what you are looking for, get a hold of Barry Coker he does fantastic work and he is a fellow forum member as well
thanks
wayne
thanks
wayne
Owner Out West Seats,Cases
www.outwestcountry.ca
www.outwestcountry.ca
- Scott Denniston
- Posts: 855
- Joined: 19 Jan 2004 1:01 am
- Location: Hahns Peak, Colorado, USA