Emmons pp pull rods

Tom Higgins · Post by **Tom Higgins** » 17 Nov 2021 11:07 pm

Hi,is there a source for these? I need a couple of long ones for C6`th pedal raises.Not pedal rods,the bellcrank to changer ones.My guitar is from 1970. Thanks.

Lynn Stafford · Post by **Lynn Stafford** » 18 Nov 2021 11:34 am

Tom,

Do you have a welding supply store nearby? If so, they sell 1/8" diameter by 36" long stainless welding rod. I usually buy 308 series alloy, if I remember correctly and it's fairly inexpensive. The brand I bought had the series stamped on a flat on each end. Those flats are handy for drilling a hole for raise hooks to use for pull rods.

Tom Higgins · Post by **Tom Higgins** » 18 Nov 2021 9:58 pm

Thanks,Lynn,I`ll look into that.

Jim Sliff · Post by **Jim Sliff** » 22 Nov 2021 4:25 pm

Also contact Kelcey O'Neil at Emmons Guitar company - they are making Push Pulls again, and may have parts available. If not, they'll certainly know where to get the right ones!

http://www.emmonsguitar.co/