Quilter TT15 Volume issue.
Moderator: Shoshanah Marohn
-
- Posts: 379
- Joined: 18 May 2009 10:19 pm
- Location: Henrietta, Tx
Quilter TT15 Volume issue.
Just wondering if anyone has had any issues with volume. I played a job tonight and had master and gain maxed out and it was adequate but I’m thinking it should have been way louder at those levels. On my Steelaire I max master and run the gains at 4 at the most.
- Jack Stoner
- Posts: 22087
- Joined: 3 Dec 1999 1:01 am
- Location: Kansas City, MO
My TB202 has more volume than I need.
Were you using any effects? or maybe a problem with the volume pedal.
Try it with just guitar to amp first and see if you have full volume. If OK then add volume pedal and try again. If OK, add whatever effects and try again. If everything is OK it could have been a bad guitar cord connection somewhere in the chain or even low AC power voltage.
Were you using any effects? or maybe a problem with the volume pedal.
Try it with just guitar to amp first and see if you have full volume. If OK then add volume pedal and try again. If OK, add whatever effects and try again. If everything is OK it could have been a bad guitar cord connection somewhere in the chain or even low AC power voltage.
GFI Ultra Keyless S-10 with pad (Black of course) TB202 amp, Hilton VP, Steelers Choice sidekick seat, SIT Strings (all for sale as package)
Cakewalk by Bandlab and Studio One V4.6 pro DAWs, MOTU Ultralite MK5 recording interface unit
Cakewalk by Bandlab and Studio One V4.6 pro DAWs, MOTU Ultralite MK5 recording interface unit
-
- Posts: 379
- Joined: 18 May 2009 10:19 pm
- Location: Henrietta, Tx
Maybe a dumb question, but how about the limiter? You didn't mention that....Bobby Hearn wrote:Thanks Jack, gonna do some checks today and see what I come up with.
--Al Evans
2018 MSA Legend, 2018 ZumSteel Encore, 2015 Mullen G2, G&L S-500, G&L ASAT, G&L LB-100, Godin A4 Fretless, Kinscherff High Noon
-
- Posts: 379
- Joined: 18 May 2009 10:19 pm
- Location: Henrietta, Tx
OK. I have assumed that, as a limiter, it would limit the maximum signal passing out of the preamp to the power amp. But I haven't tried it at high volume levels.Jon Light wrote:The limiter will NOT have a noticeable affect on the volume, no matter how it is set. Its subtle impact is on hair/overdrive/'sag' when the gain is turned up.
--Al Evans
2018 MSA Legend, 2018 ZumSteel Encore, 2015 Mullen G2, G&L S-500, G&L ASAT, G&L LB-100, Godin A4 Fretless, Kinscherff High Noon
-
- Posts: 379
- Joined: 18 May 2009 10:19 pm
- Location: Henrietta, Tx
- Jack Stoner
- Posts: 22087
- Joined: 3 Dec 1999 1:01 am
- Location: Kansas City, MO
The TT 15 is 4 ohms.Bobby Hearn wrote:Do yo plug into the 4 ohm or the 8 ohm Jack?
GFI Ultra Keyless S-10 with pad (Black of course) TB202 amp, Hilton VP, Steelers Choice sidekick seat, SIT Strings (all for sale as package)
Cakewalk by Bandlab and Studio One V4.6 pro DAWs, MOTU Ultralite MK5 recording interface unit
Cakewalk by Bandlab and Studio One V4.6 pro DAWs, MOTU Ultralite MK5 recording interface unit
- Malcolm McMaster
- Posts: 1416
- Joined: 30 May 1999 12:01 am
- Location: Beith Ayrshire Scotland
Bobby, some of us had problems with volume on Steelaire, lots of previous posts on this.
MSA Millenium SD10, GK MB200, Sica 12inch cab, Joyo American Sound Pedal/ Jay Ganz Straight Ahead amp, Telonics 15inch in Peavey cab, Digitech RP150, Peterson tuner.Hilton volume pedal.Scott Dixon seat and guitar flight case.
- Jack Stoner
- Posts: 22087
- Joined: 3 Dec 1999 1:01 am
- Location: Kansas City, MO
This thread is not about a Steelaire volume problem. The TT15 uses the Quilter TB202 amp.Malcolm McMaster wrote:Bobby, some of us had problems with volume on Steelaire, lots of previous posts on this.
GFI Ultra Keyless S-10 with pad (Black of course) TB202 amp, Hilton VP, Steelers Choice sidekick seat, SIT Strings (all for sale as package)
Cakewalk by Bandlab and Studio One V4.6 pro DAWs, MOTU Ultralite MK5 recording interface unit
Cakewalk by Bandlab and Studio One V4.6 pro DAWs, MOTU Ultralite MK5 recording interface unit
- Malcolm McMaster
- Posts: 1416
- Joined: 30 May 1999 12:01 am
- Location: Beith Ayrshire Scotland
Jack, I am well aware what the post subject is.I am pointing out to OP that there have been volume problems with other Quilter products.
MSA Millenium SD10, GK MB200, Sica 12inch cab, Joyo American Sound Pedal/ Jay Ganz Straight Ahead amp, Telonics 15inch in Peavey cab, Digitech RP150, Peterson tuner.Hilton volume pedal.Scott Dixon seat and guitar flight case.
- Travis Toy
- Posts: 571
- Joined: 29 Apr 2005 12:01 am
- Location: Nashville, TN, USA
- Contact:
Re: Quilter TT15 Volume issue.
Bobby, did you get this figured out? With master and gain both turned all the way up, it should be insanely loud. Like, you shouldn't be able to stand to be anywhere near it.Bobby Hearn wrote:Just wondering if anyone has had any issues with volume. I played a job tonight and had master and gain maxed out and it was adequate but I’m thinking it should have been way louder at those levels. On my Steelaire I max master and run the gains at 4 at the most.
-t
- Michael Stephens
- Posts: 214
- Joined: 24 May 2008 6:50 am
- Location: South Hadley, MA