Kline S-12 extended E9 4x5
-
- Posts: 160
- Joined: 20 Feb 2005 1:01 am
- Location: Edmonton, Alberta, Canada
Kline S-12 extended E9 4x5
Looking to get $2000 USD shipped and insured.
-
- Posts: 160
- Joined: 20 Feb 2005 1:01 am
- Location: Edmonton, Alberta, Canada
-
- Posts: 1073
- Joined: 25 May 2005 12:01 am
- Location: California, USA
Niiiice!
Oh Lahawdie Goosebumps! Super 😊 deal! GLWTS
-
- Posts: 160
- Joined: 20 Feb 2005 1:01 am
- Location: Edmonton, Alberta, Canada
-
- Posts: 1901
- Joined: 29 Aug 1998 12:01 am
- Location: Waterbury Ctr. VT 05677 USA
-
- Posts: 160
- Joined: 20 Feb 2005 1:01 am
- Location: Edmonton, Alberta, Canada
-
- Posts: 263
- Joined: 17 Oct 2005 12:01 am
- Location: Knoxville, Tennessee, USA
- Contact:
- Damir Besic
- Posts: 12261
- Joined: 30 Oct 2000 1:01 am
- Location: Nashville,TN.
- Contact:
Gavin Dunn wrote:That is a question I don’t have an answer for. I’m the third owner that I know of, and it’s been an extended E9 the whole time. Though I do have the hardware for another knee lever. It came to me as a 4x6.
look if there is some extra holes underneath the guitar, if there is, that means someone took some stuff out... I have never seen Kline S12 E9 ext , all 12 string Klines were U12 7+5 that I’ve seen so far...
- Dave Zirbel
- Posts: 4170
- Joined: 4 Aug 1998 11:00 pm
- Location: Sebastopol, CA USA
-
- Posts: 160
- Joined: 20 Feb 2005 1:01 am
- Location: Edmonton, Alberta, Canada
-
- Posts: 1901
- Joined: 29 Aug 1998 12:01 am
- Location: Waterbury Ctr. VT 05677 USA
- Damir Besic
- Posts: 12261
- Joined: 30 Oct 2000 1:01 am
- Location: Nashville,TN.
- Contact:
that is correct, so I guess there is no way to figure it out if it ever was U12 or not, at least not by some extra holes in the cabinet, you may be able to tell by some other signs, but I'm no Kline expert, so I don't know.... maybe by serial number, if there is a model of the guitar a part of the serial number...Alan Cook wrote:A Kline carries all the lever and pedal cross shafts on two long side rails that are pre drilled and tapped to carry existing and additional changes so there should be no holes under the guitar. The pedal bar is the same, pre drilled to except a maximum of 10 pedals I think.
Alan.
-
- Posts: 160
- Joined: 20 Feb 2005 1:01 am
- Location: Edmonton, Alberta, Canada