Bracket for mounting Volume Pedal to Emmons Pedal bar

Gerald Shaw · Post by **Gerald Shaw** » 6 Dec 2015 12:30 pm

I've got a Hilton pedal that came with the hardware to mount to an Emmmons pedal bar. I believe there is some hardware that I'm missing on my pedal bar. My pedal bar has 1 empty hole on top and 2 emptily holes on the underside. So I can't mount the pedal to the bar (at least using the set up the Hilton pedal came with)

Would I be able to purchase the missing hardware for the Pedal bar? Is it just as good to just get a mounting bracket that rides over the pedal bar and forget about using the hardware that came with the pedal?

Mike Cascio · Post by **Mike Cascio** » 6 Dec 2015 1:51 pm

the top hole is for locating pin on top of Pedal the bottom holes are for two tab the pedal sits on.I have hilte and original Emmons . after I cleaned pot on Emmons when back to that. if I remember right I got the bottom tabs from mike cases.will take picks and send.

Mike Cascio · Post by **Mike Cascio** » 6 Dec 2015 1:58 pm

hope these help