My new Clinesmith is on the way !
Moderator: Brad Bechtel
- Stu Schulman
- Posts: 6526
- Joined: 15 Oct 1998 12:01 am
- Location: Ulster Park New Yawk (deceased)
Bob,I've never seen a cooler steel guitar than that!Play your heart out on it when it shows up.
Steeltronics Z-pickup,Desert Rose S-10 4+5,Desert Rose Keyless S-10 3+5... Mullen G2 S-10 3+5,Telonics 206 pickups,Telonics volume pedal.,Blanton SD -10,Emmons GS_10...Zirctone bar,Bill Groner Bar...any amp that isn't broken.Steel Seat.Com seats...Licking paint chips off of Chinese Toys since 1952.
-
- Posts: 371
- Joined: 9 Jan 2007 8:59 am
- Location: Oklahoma, USA
- Bob Hoffnar
- Posts: 9244
- Joined: 4 Aug 1998 11:00 pm
- Location: Austin, Tx
- Contact:
- Charles Kleinert
- Posts: 78
- Joined: 7 Apr 2008 11:26 am
- Location: Briggs, Texas, USA
- Todd Clinesmith
- Posts: 1193
- Joined: 8 Dec 2003 1:01 am
- Location: Lone Rock Free State Oregon
- Contact:
- Jerome Hawkes
- Posts: 1385
- Joined: 8 May 2009 7:16 am
- Location: Fayetteville, North Carolina, USA
todd - it would sure be interesting to see a shot of the undercarriage / tone changers - i've never seen one and the bigsby book didnt go into any detail about them unfortunately.
what are most people asking for regarding changes on the e9 neck - isaac's setup, or what?
what are most people asking for regarding changes on the e9 neck - isaac's setup, or what?
'65 Sho-Bud D-10 Permanent • '54 Fender Dual-8 • Clinesmith T-8 • '38 Ric Bakelite • '92 Emmons D-10 Legrande II
-
- Posts: 497
- Joined: 12 Jul 2004 12:01 am
- Location: USA
- Jerome Hawkes
- Posts: 1385
- Joined: 8 May 2009 7:16 am
- Location: Fayetteville, North Carolina, USA
- Todd Clinesmith
- Posts: 1193
- Joined: 8 Dec 2003 1:01 am
- Location: Lone Rock Free State Oregon
- Contact:
Steve's guitar weighed in at 62 lbs in the case. The non pedals are quite a bit lighter. But really not bad compared to most pedal steels out there. My old sho-bud weighed more. I think there is many general misconceptions when it comes to Bigsby's or that "style guitars". That they weigh a lot, or break strings, break cables,or don't hold tune, ect ect. Sometimes rumors overtake the truth and usually the ones who spread the rumors are not in the know. I have seen it on the forum and heard it at steel shows.
Anyways here are a few photos of the undercarriage of Steve Walz guitar.I did not want to post this in the non pedal area but the request was made and it is mostly non pedal guys into these instruments. This copedant is about as far as this guitar in a D-10 fashion can go, a triple would allow more room for changes.
Photo in the spray booth/ photo booth
Anyways here are a few photos of the undercarriage of Steve Walz guitar.I did not want to post this in the non pedal area but the request was made and it is mostly non pedal guys into these instruments. This copedant is about as far as this guitar in a D-10 fashion can go, a triple would allow more room for changes.
Photo in the spray booth/ photo booth
-
- Posts: 2134
- Joined: 27 Aug 2001 12:01 am
- Location: Helsinki, Finland
- Contact:
-
- Posts: 37
- Joined: 20 Feb 2009 2:40 pm
- Location: New York, NY
- Todd Clinesmith
- Posts: 1193
- Joined: 8 Dec 2003 1:01 am
- Location: Lone Rock Free State Oregon
- Contact:
Jerome,
Most folks want a straight steel but for "Tone Changers" the basic 6th changes... like Steve mentioned P5 -P7... or more. And/Or the Isaacs.
Thanks for the comments Jussi. I was checking out your my space page the other day to listen to "Lorraine in the Morning" again and noticed the photo of you playing my lap steel ! Cool to see. BTW is that recording awith LITM available somewhere?
Bill Thanks for noticing. It's a lot more work than most imagine.
Todd
Most folks want a straight steel but for "Tone Changers" the basic 6th changes... like Steve mentioned P5 -P7... or more. And/Or the Isaacs.
Thanks for the comments Jussi. I was checking out your my space page the other day to listen to "Lorraine in the Morning" again and noticed the photo of you playing my lap steel ! Cool to see. BTW is that recording awith LITM available somewhere?
Bill Thanks for noticing. It's a lot more work than most imagine.
Todd
- Bob Hoffnar
- Posts: 9244
- Joined: 4 Aug 1998 11:00 pm
- Location: Austin, Tx
- Contact:
I'm playing the Clinesmith friday night with The Hubcaps
http://www.seancastilloandthehubcaps.com/
in San Antonio at Jack's Patio
then early show with Wayne Hancock on saturday in New Caney, Texas
http://www.myspace.com/waynehancock
I'll bring along a lap steel for anybody to check out also.
http://www.seancastilloandthehubcaps.com/
in San Antonio at Jack's Patio
then early show with Wayne Hancock on saturday in New Caney, Texas
http://www.myspace.com/waynehancock
I'll bring along a lap steel for anybody to check out also.
Bob
-
- Posts: 2134
- Joined: 27 Aug 2001 12:01 am
- Location: Helsinki, Finland
- Contact:
- Thomas Ludwig
- Posts: 329
- Joined: 31 Jan 2006 1:01 am
- Location: Augsburg, Germany
- Bob Hoffnar
- Posts: 9244
- Joined: 4 Aug 1998 11:00 pm
- Location: Austin, Tx
- Contact:
Thomas,
I'll be in Europe in April. Depending on airline baggage I'll either have the D10 console or a Clinesmith lap with me.
Check Wayne's myspace for info
http://www.myspace.com/waynehancock
I'll be in Europe in April. Depending on airline baggage I'll either have the D10 console or a Clinesmith lap with me.
Check Wayne's myspace for info
http://www.myspace.com/waynehancock
Bob
-
- Posts: 1557
- Joined: 6 Feb 2009 5:15 pm
- Location: Corinth Mississippi
-
- Posts: 371
- Joined: 9 Jan 2007 8:59 am
- Location: Oklahoma, USA
-
- Posts: 1557
- Joined: 6 Feb 2009 5:15 pm
- Location: Corinth Mississippi
-
- Posts: 2175
- Joined: 20 Feb 2007 4:10 pm
- Location: Indiana, USA
- Todd Clinesmith
- Posts: 1193
- Joined: 8 Dec 2003 1:01 am
- Location: Lone Rock Free State Oregon
- Contact:
I have been meaning to update my web site for a while now. The lap steels are not up, or current guitars. The instruments on there are my 2 prototypes. Alot has changed since those two guitars. Mostly minor details but , finish, logo ect.
Daniel heres a photo of a Triple 47' style. I think I have put this photo up before . Mike Neer has posted some lap steel sound clips.
Also Mid 50's style:
I'll have some more triple photos to post at the end of march or april.
Todd
Daniel heres a photo of a Triple 47' style. I think I have put this photo up before . Mike Neer has posted some lap steel sound clips.
Also Mid 50's style:
I'll have some more triple photos to post at the end of march or april.
Todd
- Tom Pettingill
- Posts: 2246
- Joined: 23 Apr 2007 11:10 am
- Location: California, USA (deceased)
-
- Posts: 1557
- Joined: 6 Feb 2009 5:15 pm
- Location: Corinth Mississippi