The Steel Guitar Forum

Hey gurus.

I picked up a little Marshall G10-Mk. II amp at Goodwill the other day for 20$ to give my grandson but it needs some replacement parts. It works well but must have been knocked over with the guitar and earhopnes plugged in. When I opened the case to see if I could tighten those plastic jacks up a bit I found that the backs had been pushed out and they need replacing. Since they solder directly to the board I need an exact replacement. Where do I go for these?

Thanks in advance.

ObeWanKobe

------------------
Gibson D-8 Console Grande - Stringmaster T-8 - Alkire EHarp D-10
Fender Super Reverb
kobe@austin.rr.com
http://home.austin.rr.com/kobeco

<A HREF="http://www.tubesandmore.com/?OVRAW=mars ... C=standard" TARGET=_blank>


look at page 48 at the following site:
http://www.tubesandmore.com/?OVRAW=marshall%20parts&OVKEY=marshall%20part&OVMTC=standard[/url]
http://www.marshallparts.com/ <font size="1" color="#8e236b"><p align="center">[This message was edited by Ken Fox on 08 September 2005 at 04:36 PM.]</p></FONT>

Err, ship me that stringmaster and I'll tell you.

[/jedi mind trick]

-MG

Sure wouldn't be worth it to ship it to Marshall over there.

Which stringmaster Mike? I have several.

------------------
Gibson D-8 Console Grande - Stringmaster T-8 - Alkire EHarp D-10
Fender Super Reverb
kobe@austin.rr.com
http://home.austin.rr.com/kobeco