Sho-Bud volume pedal

Mike Black · From: New Mexico, USA

I bought a Sho~Bud pedal that I'm going to fix up and give to my pal for his D-8 Sho~Bud. It's Ben Keith's old steel and he needs to have a matching pedal for it!
The string is missing and needs to be replaced The rest of the pedal is intact except the bottom plate is missing. Can one of you folks that owns one send me a jpg or 2 of the inside so I can see how the string is wound and anchored? I also would like to see a photo or tracing of the bottom plate. Thanks for the help.

[This message was edited by Mike Black on 14 January 2003 at 07:16 PM.]

Mike Black · From: New Mexico, USA

Still looking for a jpgs of the workings of a Sho~Bud pedal. I'll swap jpgs of Bigbsy or Fender Vol/Tone or Volume only pedals.
A picture's worth a 1000 words!

[This message was edited by Mike Black on 17 January 2003 at 08:40 PM.]

Jim Palenscar · From: Oceanside, Calif, USA

Mike - see this article by Jeff- I have a ShoBud pedal as well and it is the same as the Goodrich, etc~ http://www.steelguitarinfo.com/other/volumepedal/pot_change.html

Bill Ford · From: Graniteville SC Aiken

Mike,
Check your email
The measurements on the plate is 3"x8",the hole spaceing is 2 1/2"x7 1/2"
BF

------------------
Bill Ford

[This message was edited by Bill Ford on 20 January 2003 at 04:12 PM.]

Forum Index > Electronics		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: