Tubefex Question

Bob I. Williams · From: Sun City West, Arizona, USA

I just had the battery replaced. when I got it back I noticed the global settings are at "0" I put the output at 100 do you folks have the setting for the input level,low,mid,high Thanks for your help
BOB

b0b · From: Cloverdale, CA, USA

Moved to 'Electronics', where the experts are.

Ken Fox · From: Nashville GA USA

I would start with all of the EQ settings at "mid" point (flat response). Turn the output level to "off" and set the input to a level that allows the peak indicator to blink on your loudest playing notes, bass notes will drive it to clipping the quickest (check it out with the C6th neck). After all that, raise your output to the level necessary to get your working volume. Jack Stoner may also have some settings over on his site, not for sure.
Buddy Emmons has mentioned a similar procedure over on his site, check out his forum page there as well.

[This message was edited by Ken Fox on 30 June 2002 at 09:08 AM.]

Forum Index > Electronics		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: