Blinking active light, Profex II

Ken Fox · From: Nashville GA USA

Active (green) light blinks with no pattern at all. Seems to still respond to input signal OK, turns red when overdriven. Does not seem to affect unit operation at all. I have replaces the battery, reinitialized, replaced a bad output pot, and replaced U602. Anyone got any ideas or had this problem? It is an early version 1.1 software. Maybe it's not a problem?

Bill Crook · From: Goodlettsville, TN , Spending my kid's inheritance

"Mabe It's not a problem"

Right

Most of them do that. Nothing to worry about.

[This message was edited by Bill Crook on 13 February 2002 at 06:31 AM.]

Forum Index > Electronics		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: