| Author |
Topic: Peavey Vegas 400 Effects Loop |
William Kendrick
From:
Bedford Heights, Ohio, USA (Goes by first name "Bill")
|
Posted 15 Mar 2024 4:09 pm |
|
Interesting problem today. I put my effects units into the Vegas 400 effects loop, instead of between the volume pedal and the amplifier. It sounds great. But when I came back to it later today, no sound. When I unplugged the effects from the effects loop and back to between the volume pedal and the amplifier, everything works. Trying to figure out what happened. I really liked using the effects loop.
_________________
1979 Emmons D-10 P/P 8X5, Lawrence L-710 Pickups, Li'l Izzy, Telonics Volume Pedal, Goodrich Super Sustain Matchbox, Lexicon MX200 Dual Reverb Effects Processor, Peavey Vegas 400 Amplifier. |
|
|
|
Ken Fox
From:
Nashville GA USA
|
Posted 16 Mar 2024 5:52 am
|
|
| Dirty or open contact on the effects in Jack. Quick fix, put a small jumper cable(pedal board cable) between the in and out jacks |
|
|
|
William Kendrick
From:
Bedford Heights, Ohio, USA (Goes by first name "Bill")
|
Posted 16 Mar 2024 6:30 am
|
|
Thanks, Ken. I figured out the problem. The input volume on one of my effects units was set too low. I assume preamp couldn't get enough signal to amplify. Turned up the unit. All is well. Thanks again.
_________________
1979 Emmons D-10 P/P 8X5, Lawrence L-710 Pickups, Li'l Izzy, Telonics Volume Pedal, Goodrich Super Sustain Matchbox, Lexicon MX200 Dual Reverb Effects Processor, Peavey Vegas 400 Amplifier. |
|
|
|
