Hi, all -
Apologies if this has been answered before but dang if I can find anything on it.
Is there someone out there who has or can fabricate a conversion to rods instead of cables for a 6-string Harlin Brothers Multi-Kord?
Any info is much appreciated!
- Tom Likely
Harlin Bros Multi-Kord cable-to-rod conversion
Moderator: J D Sauser
-
- Posts: 1
- Joined: 2 Aug 2022 12:27 pm
- Location: South Dakota, USA
-
- Posts: 1169
- Joined: 14 Oct 1999 12:01 am
- Location: Ontario, OR
I did a proper upgrade. Drill holes in the side of the pedals (gave myself a couple of different options for different amounts of pedal travel) drilled holes in the bottoms of the changer arms and put in #8 eyebolts, and attached them to 1/8" threaded rod with one of these:
https://www.mcmaster.com/products/rod-e ... -rod-ends/
The other end of the rods have these:
https://www.mcmaster.com/products/rod-e ... -linkages/
You have to increase the pedal spacing to fit the right angle variety, but I think you can buy inline versions from PSG supply places, that could thread into the tops of the pedals.
https://www.mcmaster.com/products/rod-e ... -rod-ends/
The other end of the rods have these:
https://www.mcmaster.com/products/rod-e ... -linkages/
You have to increase the pedal spacing to fit the right angle variety, but I think you can buy inline versions from PSG supply places, that could thread into the tops of the pedals.