The Steel Guitar Forum

So, I just got a new guitar in last week. It’s got extendable legs, which are much needed as I’m 6’4. And while I think I’ve got the height set to an appropriate height for my body, I’m having trouble getting all the legs set up to equal height.

So for those of you out there with extendable legs, how do you set them up consistently???

Ben, just measure how much one leg is extending out of the fatter section and make them all the same. If it rocks a little, make adjustment to the short one. Most people play with a level body setting. I don't. If you're talking pedal steel, your pedals should be set to clear the floor when depressed and be comfortable. Have fun. Ron

I keep three always at the same length (three legs will always be stable and sit flat), and then adjust the fourth, the right rear, to make it stable.

Once they're set evenly and at the proper height, you should never have to adjust the front legs.

A simple trick that I learned some time ago. Carry a few small washers that are the same diameter as the bottom of the leg extension. If you encounter a slightly uneven floor, remove the leg tip and install enough washers to make the guitar sit level. Saves the trouble of adjusting the leg to temporarily compensate.

Interesting solution, David.

I bought some plastic furniture shims (of course I keep losing the little things!) and shim up that one "odd" leg. I am now trying to not readjust legs to suit each floor. They get loose and I have had a leg sort of collapse in the middle of a set. Annoying!

Amazon calls them Wobble Wedges.

Chris

Donny Hinson wrote:I keep three always at the same length (three legs will always be stable and sit flat), and then adjust the fourth, the right rear, to make it stable.

Agreed. I just kneel behind the guitar, put my left shoulder under it to raise it or lower it as needed, adjust the right rear leg leg, tighten it, and stand up again.

It just takes moments to do.

Are you having trouble with the leg clutches slipping? If so you can cut pieces of PVC pipe or wood dowel to keep the leg at the right height, after cleaning the pieces of hte clutch https://bb.steelguitarforum.com/viewtop ... c&start=25

Dowel rod through the center tube of the legs works good.
Cut to length you want, Remove the rubber foot slide the dowel rod in, put the rubber foot back on. If you need to lengthen 1 back legs so it will set level and stable on a crooked floor.
Good Luck and Happy Steelin.

If you are trying to raise the height of the guitar to accommodate your long legs by just extending the legs, that’s not gonna work. You will either need longer legs & pedal rods or a lift kit. Unless your pedal bar has thru the leg bolts, it’s probably gonna slide up or down the small part of the leg without a solid spacer.