Page 1 of 1
Pedal Steel Guitar Tuning Nuts Fender/ Sho-Bud
Posted: 1 Jul 2021 8:18 am
by Virgil Franklin
Okay it happened... I stripped a tuning nut.
I don't have a means of determining what diameter the pull rod is so..
what would be the likely replacement nut?
Posted: 1 Jul 2021 9:44 am
by K Maul
You mean these? I think usually with new ones you fit it to the end of the rod and it cuts its own thread into the nylon nut.
https://www.google.com/search?q=pedal+s ... F0kbnmDVBM
Posted: 1 Jul 2021 10:31 am
by Virgil Franklin
Yeah.. they are a little difficult to find..
tuning nuts
Posted: 1 Jul 2021 5:54 pm
by Dave Dube
Posted: 1 Jul 2021 7:25 pm
by Bobby D. Jones
When you get some new tuning nuts, Check the end of the rod, And the first couple threads very careful.
The threads on the rod must be true to cut new threads in the nylon nut as it is threaded on.
I had a nylon nut strip out on a used steel I had, When I went to replace the tuning nut I checked the threads. It looked like the rod had been cut with a pair of pliers and mashed the threads. The bad rod had torn the threads out of the nylon nut.