Page 1 of 1
Shobud pull rod thread size???
Posted: 2 Oct 2006 12:32 pm
by Kirk Hamre
Can anyone tell me what size the threads are on a Sho Bud pull rod? I have a 1977 LDG.
Posted: 2 Oct 2006 2:57 pm
by Kirk Hamre
I'm referring to the threaded pull rod that the nylon tuners fasten to at the end of the guitar. Is it coarse or fine thread? I want to order a nut that will fit this size thread. I don't know what diameter my pull rods are. Somewhere I read that the threads are 4-40 or 5-40 in size???
Posted: 2 Oct 2006 8:03 pm
by James Morehead
If your going to use the nylon tuners, I believe they are self tapping, so just screw them on.
Posted: 2 Oct 2006 8:31 pm
by Paul Redmond
For 1/8" rods, #5-40 is most common, but some Franklin's and Sierra's used #6-40. For 7/64" rods, use a #4-40. For 3/32" rods also use a #4-40. I've worked on guitars with 1/8" rods where someone has used a #6-32 thread. This is way too coarse, usually chews up the tuner, and makes tuning less sensitive.
PRR
Posted: 2 Oct 2006 11:09 pm
by Fred Bova
What about the Fender/Sho-Bud, what size, thread on these PSG ? Also, what is a good source for the Nylon tuners?
Posted: 3 Oct 2006 6:59 am
by Barry Blackwood
Well, Paul, that clears that up!
Posted: 4 Oct 2006 11:07 am
by Kirk Hamre
Thanks for the help. I finally determined that my Sho Bud horizontal pull rods have a 5-40 thread on them at the nylon tuner end.
Posted: 4 Oct 2006 5:21 pm
by Paul Redmond
George L's sells the nylon tuners in packs of 10. You can find them on their website.
PRR