The Steel Guitar Forum Store 

Post new topic Keyless question
Reply to topic
Author Topic:  Keyless question
MUSICO

 

From:
Jeremy Williams in Spain
Post  Posted 12 Dec 2005 6:23 am    
Reply with quote

¿How much tuning leeway is there on a keyless tuner once strung?

I´ve never had a chance to see one in action. Sometimes I will tune my 12th string from B to C# for a particular tune...then tune it back at the end of the song. ¿Could I still do that on a keyless?

Apologies for my ignorance.

Jeremy Williams
Barcelona Spain
View user's profile Send private message Send e-mail

Al Terhune


From:
Newcastle, WA
Post  Posted 12 Dec 2005 6:38 am    
Reply with quote

Jeremy,

On GFIs, there's pleeeeeenty of room. I've never done it, but from going by memory of "feel," I'd say you can go to a half note up or down just by half or even quarter turn of the dial.

Al
View user's profile Send private message Send e-mail

Jerry Overstreet


From:
Louisville Ky
Post  Posted 12 Dec 2005 8:31 am    
Reply with quote

Jeremy, for folks that are not familiar with the gearless tuning system, your question is a reasonable one.

I once had a Lamar keyless D10. I owned Universals at the same time. I used to tune the C neck on the Lamar down to B to match the fret positions on the U12/14. This would take the big 10th .070 string from C down to B with raises and lowers as much as 1 1/2 tones. No problem whatsoever.

I would say this would not be a problem on either of the keyless tuners I have owned.
One of the other Unis was a Sierra 14. Seemed to be plenty of range for tuning on that one also.
View user's profile Send private message Send e-mail

Michael Johnstone


From:
Sylmar,Ca. USA
Post  Posted 12 Dec 2005 9:05 am    
Reply with quote

My Excel will do it quite easily. Although if I was gonna do it often enough for it to come up as a question,I'd just put it on a pedal. Most 12 strings already have it.
-MJ-
View user's profile Send private message Send e-mail

Jim Bob Sedgwick

 

From:
Clinton, Missouri USA
Post  Posted 12 Dec 2005 9:16 am    
Reply with quote

No problem on a Williams. Plenty of room available
View user's profile Send private message

Roy Ayres


From:
Riverview, Florida, USA, R.I.P.
Post  Posted 12 Dec 2005 11:12 am    
Reply with quote

On my Excel, I raise the tuner fingers to the top of their travel after removing the strings. After pulling a new string as tight as possible by hand, the tuner finger is about half way down when the string is in tune. With the fingers half way down, you have more room to raise or lower than you will probably ever need. (I will NEVER go back to keyed guitars.)

------------------

Visit my Web Site at RoysFootprints.com
Browse my Photo Album and be sure to sign my Guest Book.

View user's profile Send private message Send e-mail Visit poster's website

Richard Sinkler


From:
aka: Rusty Strings -- Missoula, Montana
Post  Posted 12 Dec 2005 11:43 am    
Reply with quote

I used to do it the Kline I owned with no problems.

------------------
Carter D10 9p/9k, NV400, Korg Triton Le88 Synth, Korg CX-3 organ, Yamaha Motif Rack Module, Regal Dobro, Tele, Gretsch Acoustic.

View user's profile Send private message Send e-mail

MUSICO

 

From:
Jeremy Williams in Spain
Post  Posted 13 Dec 2005 1:27 am    
Reply with quote

Thank you all. This was exactly the information I needed.

Jeremy Williams
Barcelona Spain
View user's profile Send private message Send e-mail

Doug Seymour


From:
Jamestown NY USA (deceased)
Post  Posted 13 Dec 2005 12:53 pm    
Reply with quote

Way to go Roy! I don't guess we can change the world, though?
View user's profile Send private message Send e-mail

Don McClellan

 

From:
California/Thailand
Post  Posted 15 Dec 2005 6:30 pm    
Reply with quote

Your question is a good one. Keep in mind that when you put a low string on you can actually string it too tight with your fingers to begin with. So, you could easily tune a string up a step or more (and then back) but you might not be able to tune a sting down a whole step if you put it on very tight to begin with.
View user's profile Send private message Send e-mail

Don McClellan

 

From:
California/Thailand
Post  Posted 15 Dec 2005 6:32 pm    
Reply with quote

Your question is a good one. Keep in mind that when you put a low string on you can actually string it too tight with your fingers to begin with. So, you could easily tune a string up a step or more (and then back) but you might not be able to tune a sting down a whole step if you put it on very tight to begin with.
View user's profile Send private message Send e-mail


All times are GMT - 8 Hours
Jump to:  

Our Online Catalog
Strings, CDs, instruction,
steel guitars & accessories

www.SteelGuitarShopper.com

Please review our Forum Rules and Policies

Steel Guitar Forum LLC
PO Box 237
Mount Horeb, WI 53572 USA


Click Here to Send a Donation

Email admin@steelguitarforum.com for technical support.


BIAB Styles
Ray Price Shuffles for
Band-in-a-Box

by Jim Baron
HTTP