Page 1 of 1
Nashville 112 Reverb Squealing!
Posted: 15 Oct 2017 2:48 pm
by Jeff Metz Jr.
If I turn my reverb up past 3 It begins a gradual squeal that eventually reaches a deafening volume level. If I turn the reverb knob down it goes away.
I would like to add a bit more reverb but this is hindering that option.
BTW this amp has a telonics 12" neo speaker and a MOD reverb Tank.
Thanks
Posted: 16 Oct 2017 6:14 am
by Jack Stoner
I would suspect the "mod" reverb tank. Either defective, wrong impedance model, or possibly how or where its mounted.
It should be mounted on the bottom and as far the rear of the cabinet as possible to get away from the speaker. For testing, move the reverb tank out of the cabinet (as far as the cables will allow) and see if it makes any difference.
Pinching the tank
Posted: 30 Oct 2017 6:23 am
by Tim Mathews
Sometimes if you have things "stuffed" into the back of the amp footwitch, stomp boxes, etc they can immobilize and transfer cabinet vibration to the tank causing what you describe. The reverb tank should always be loosely
attached and able to move. Hence the bag it sits in on the 112
Posted: 12 Nov 2017 7:30 am
by Dag Wolf
I have the same problem with one of mine nv112 reverb. I`ve a couple and switched the reverb tank. The problem follows the tank.
Anyone got any tips or is the tank defect?
Thanks,
Dag
possible fix
Posted: 14 Nov 2017 7:04 pm
by Jerry Knapper
I have an older KK ShoBud amp that often was noisy as I increase the reverb and then it would feedback. I played with it trying different things and discovered it was the tank itself causing the feedback. If I squeezed the tank it would stop. Thinking it was just my hand, I put a pinch clamp on it and that stopped it also. However, it wasn't practical to put a clamp on it so I played around some more and finally found that if I put some insulation between the board the tank was mounted on it would dampen the vibration. Experimenting with several things, I put some blue anti skid stuff like you might use to keep something from slipping around on something that is moving. I put it between the tank and base board making sure it was snug and wouldn't contact with the springs. Then I wrapped it around the tank, put it all back in the vinyl covering, sealed the end of the vinyl completely and fastened it down to the quietest place on the bottom of the cabinet. It is now quiet and doesn't feedback.
You might try it, or swing over to Polk City and I'll help you with it. Jerry Knapper