| Author |
Topic: Mica Sunburst Finish |
Tom Campbell
From:
Houston, Texas, USA
|
Posted 19 Dec 2016 4:11 pm |
|
Is there such an option as a Mica -Sunburst finish?
I don't recall ever seeing one, but that doesn't mean its not feasible. Might be more durable than the lacquer sunburst finishes. |
|
|
|
Larry Baker
From:
Columbia, Mo. U.S.A.
|
Posted 19 Dec 2016 7:20 pm
|
|
Check with Mike at Mullen, they are doing some amazing finishes now.
_________________
Mullen G2 SD10 3 & 5 The Eagle
NV112 amp===Earnie Ball V.P. |
|
|
|
Erv Niehaus
From:
Litchfield, MN, USA
|
Posted 20 Dec 2016 9:20 am
|
|
I doubt if you could do a sunburst in just mica.
I suppose you could do some shading with lacquer on the ends of the guitar. |
|
|
|
Tom Campbell
From:
Houston, Texas, USA
|
Posted 20 Dec 2016 12:01 pm
|
|
| The mica surface might have to be "etched" in order for the applied paint to bond. Most ultra smooth surfaces need some sort of pre-prepping. |
|
|
|
Ian Worley
From:
Sacramento, CA
|
Posted 20 Dec 2016 12:44 pm
|
|
The colors/patterns in plastic laminate are printed on paper and embedded in phenolic resin. I've never seen a sunburst pattern in a production laminate, but I know some manufacturers (like Wilsonart) will make custom sheets from digital art. It's pricey but quite doable and not uncommon.
You would have to produce a high-res photo of the sunburst pattern on a flat plane with the look, the type of wood and colors etc. you wanted, email it to them and they would produce the material in a sheet(s). |
|
|
|
