Page 1 of 1
20 degree 1/2" #13 sockets
Posted: 15 Dec 2016 5:26 am
by Gary Rue
Any 20 degree angle leg sockets out there? I want to kick out the center leg on my laps. Thanks, Gary.
Posted: 15 Dec 2016 8:43 am
by Erv Niehaus
Get ahold of Gary Sill and ask him the angle on his flanges.
gary sill
Posted: 15 Dec 2016 2:22 pm
by Gary Rue
Thanks Erv,
I get my sockets from Gary. Great sockets. They are 15 degrees. I want 20 degrees on the center leg because of the narrowness of my guitars. Trying not to have to do yet another prototype. $ !
Posted: 15 Dec 2016 2:37 pm
by Erv Niehaus
Gary's flanges are pretty thick, maybe you could grind down one side of the flange to get a greater angle, just a suggestion.
Why not
Posted: 15 Dec 2016 4:08 pm
by Gary Rue
Better yet, I will simply angle the center hole by changing the angle on the drill press table. I should have had a V8 or slept at the right Hotel! Oh well.
Posted: 16 Dec 2016 8:29 am
by Erv Niehaus
The hole is already in the flange, you'll screw up the thread.
Posted: 16 Dec 2016 3:36 pm
by Harry McIlwain
You could take the correct size forstner bit and angle the recess in guitar body slightly until you get the desired angle. Harry.
thanks what Idid.
Posted: 16 Dec 2016 5:09 pm
by Gary Rue
Thanks guys. Thats what I did Harry. It was to easy to think of! Yikes! Why does the easy fix hide between my ears?
Posted: 16 Dec 2016 5:41 pm
by Harry McIlwain
Many things hide between my old ears Gary, never to be found again.
delete post
Posted: 18 Dec 2016 6:15 am
by Gary Rue
Bob, you can delete this one.Missed the obovious. I can deepen the holes and make angled spacers at any degree I wish.