Page 1 of 1
Tone Block direct out..not working
Posted: 5 Oct 2016 6:17 pm
by Dennis Detweiler
I get no signal out of the balanced direct out unless I unplug from the speaker input? I can't get a signal from both outputs at the same time? I don't think it should operate that way. Anyone have that same problem?
I emailed Quilter, but haven't had a response yet.
Posted: 7 Oct 2016 9:04 am
by Chris Parks
Just in case you haven't had a chance to get to the email...
(From Pat Quilter)
Hello Dennis
The Direct Out should get a little louder without the speaker but it should work either way and provide a mic-level signal similar to what you would get by miking the speaker. Please confirm that your XLR cable is good (you could check it with a mic) and ensure there are no conflicting grounds on the speaker output signal.
Best regards
Pat Quilter