Page 1 of 1
How do I re-position a pullrod?
Posted: 4 Jun 2016 3:13 pm
by Mitchell Blum
I need to reduce the slack/change the action on my GFI pedals. Can anyone explain how to change the position of the pull rod at the pull bar and/or the changer fingers?
Posted: 4 Jun 2016 4:23 pm
by Mitchell Blum
Wow. Maybe I'll just surgically lengthen my left leg . . .
Posted: 4 Jun 2016 5:00 pm
by Mitchell Blum
Thanks for the prompt reply and encouragement I'll attempt it -- glad to have a trailblazer out there!
Thanks
Mitch
Posted: 4 Jun 2016 5:19 pm
by Lane Gray
It looks dead easy.
Loosen screw, slide out rod (that's clever, having the rod hold the puller in), pop the puller out, move it to the new hole, slide the rod back in, tighten screw.
Posted: 4 Jun 2016 7:26 pm
by Mitchell Blum
Too easy! No hole change. All that was needed was to (1) loosen ferrule screw (2) take up some slack in the rod (3) re-tighten and that was it.
Thanks guys,
Mitch