Neck Selector Switch Diagram Needed

Steve Alonzo Walker · From: Spartanburg,S.C. USA (deceased)

I Need A Wiring Diagram For The Neck Selector Switch With Tone Control On An Emmons D-10 If Anyone Can Help Me. *

[This message was edited by Steve Alonzo Walker on 14 July 2004 at 04:10 AM.]

Steve Alonzo Walker · From: Spartanburg,S.C. USA (deceased)

Bill Ferguson · From: Milton, FL USA

Steve, I will be glad to draw it out and email it to you tonight when I get home if you would like.

Bill

Ben Slaughter · From: Madera, California

Check this site, got a schematic for wiring a third P/U in my tele here.
http://www.seymourduncan.com/website/support/schematics.shtml

------------------
Ben
Zum D10, NV400, TubeFex, POD, G&L Guitars, etc, etc.

Chris Lucker · From: Los Angeles, California USA

Emmons will fax you a wiring layout page that has single neck, double neck and double split coil wirings.
Chris

Stephen Gambrell · From: Over there

Bring the guitar to the house, we'll wire it up on the kitchen table.

Forum Index > Pedal Steel		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: