MSA Rebuild

Steve English · From: Baja, Arizona

I'm rebuilding an S-10 MSA 5+4. Does anyone have an original, factory set-up on their MSA that I could get info on. I would like to know which of the four holes on the fingers are used for the pull rods (all pulls, all pedals). For example: A pedal= use 2nd hole from top at changer to 2nd hole on finger from cross rod for low string, 1st hole on finger from cross rod for high string.
It took me just a few minutes to "map" out all the pulls on paper before I disassembled the guitar, however it's obvious this one's been taken apart before and I'd really like the original factory set-up. I can e-mail someone a pre-made form to enter information on. Can anyone help?

John Fabian · From: Mesquite, Texas USA * R.I.P.

You'll find copies of the original owners manuals here as well as a rodding chart you can use as a basis for rodding the MSA.
http://www.steelguitarinfo.com/downloads/OwnersManuals/index.html
http://www.steelguitarinfo.com/rodding/roddingindex.html

------------------
John Fabian
Carter Steel Guitars

www.steelguitar.com
www.steelguitarinfo.com
www.carterstarter.com

Forum Index > Pedal Steel		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: