The Steel Guitar Forum

I've got a Hilton pedal that came with the hardware to mount to an Emmmons pedal bar. I believe there is some hardware that I'm missing on my pedal bar. My pedal bar has 1 empty hole on top and 2 emptily holes on the underside. So I can't mount the pedal to the bar (at least using the set up the Hilton pedal came with)

Would I be able to purchase the missing hardware for the Pedal bar? Is it just as good to just get a mounting bracket that rides over the pedal bar and forget about using the hardware that came with the pedal?

the top hole is for locating pin on top of Pedal the bottom holes are for two tab the pedal sits on.I have hilte and original Emmons . after I cleaned pot on Emmons when back to that. if I remember right I got the bottom tabs from mike cases.will take picks and send.

hope these help