Page 1 of 1
Peterson turner power supply
Posted: 3 Aug 2015 1:14 pm
by Cody Russell
My strobo flip will not work with the power cable. Batteries all good. I can't figure out if it's on the turner side or power supply side because I can't find that particular power supply. Any thoughts? I'd rather not order a new power supply if I have to order a whole new unit.
Posted: 3 Aug 2015 1:28 pm
by Howard Parker
Frankly (and fwiw),
I'd not worry about a supply and just run it on batteries. I may change 2-3 times a year and I get PLENTY of warning as the display gradually dims.
Just one less adapter I have to worry about.
YMMV
hp
Posted: 3 Aug 2015 4:15 pm
by Ron Whitworth
The power supply is available by itself - you can get that here
https://www.petersontuners.com/shop/ite ... wer-Supply
I would first plug yours in & check the output with
a multimeter to verify it is bad.
Just my .02(
Ron
Posted: 3 Aug 2015 4:24 pm
by Stephen Cowell
Petersen Strobo-flip uses 5VDC, regulated... you can use any USB phone charger to create that voltage... just cut the wire at the end that connects to the phone and connect the red to tip, black to sleeve (ground). I've lost mine, so I'll be doing the exact same thing soon.