The Steel Guitar Forum Store 

Post new topic Removing Carter Pedals from the pedal bar???
Reply to topic
Author Topic:  Removing Carter Pedals from the pedal bar???
Tom Campbell

 

From:
Houston, Texas, USA
Post  Posted 1 Mar 2015 2:12 pm    
Reply with quote

What is the process for removing pedals from the Carter pedal bar?
There looks like there is some kind of set screw on each end of the first and last pedal...but I can't fine what type of allen type wrench will remove the pin.
View user's profile Send private message Send e-mail

Howard Parker


From:
Maryland
Post  Posted 1 Mar 2015 2:27 pm    
Reply with quote

Without checking as I'm away from the steel. It might well require a torx wrench, not an allen.

If that helps a little.

h
View user's profile Send private message Send e-mail Visit poster's website

Richard Sinkler


From:
aka: Rusty Strings -- Missoula, Montana
Post  Posted 1 Mar 2015 3:04 pm    
Reply with quote

The little blocks at the end of the pedals, do indeed, have a set screw. That locks the block onto the rod the pedals are mounted on. To get the pedals off, you need too remove these blocks, and the phillips screw on the bottom of the pedal bar, and the pedals will slide off. Make sure you tighten those set screws when you put the pedals back on. They keep the rod from sliding back and forth when you use the pedals. I don't think the rod would slide enough for a pedal to fall off.

It is a hex head set screw, not a torx.
_________________
Carter D10 8p/8k, Dekley S10 3p/4k C6 setup,Regal RD40 Dobro, Recording King Professional Dobro, NV400, NV112,Ibanez Gio guitar, Epiphone SG Special (open D slide guitar) . Playing for 55 years and still counting.
View user's profile Send private message Send e-mail

Howard Parker


From:
Maryland
Post  Posted 1 Mar 2015 3:08 pm    
Reply with quote

Thanks Richard!

h
View user's profile Send private message Send e-mail Visit poster's website

Tom Campbell

 

From:
Houston, Texas, USA
Post  Posted 1 Mar 2015 5:13 pm    
Reply with quote

Thanks for the info. It is a hex set screw...1/16"

I've worked on a lot of Sierra's and older MSA's. This Carter is new territory for me. It is a U12 that I bought form a gentlemen that rarely played it...it's a 1999 build.
View user's profile Send private message Send e-mail

Richard Sinkler


From:
aka: Rusty Strings -- Missoula, Montana
Post  Posted 1 Mar 2015 6:07 pm    
Reply with quote

Carters are easy to work on.
_________________
Carter D10 8p/8k, Dekley S10 3p/4k C6 setup,Regal RD40 Dobro, Recording King Professional Dobro, NV400, NV112,Ibanez Gio guitar, Epiphone SG Special (open D slide guitar) . Playing for 55 years and still counting.
View user's profile Send private message Send e-mail


All times are GMT - 8 Hours
Jump to:  

Our Online Catalog
Strings, CDs, instruction,
steel guitars & accessories

www.SteelGuitarShopper.com

Please review our Forum Rules and Policies

Steel Guitar Forum LLC
PO Box 237
Mount Horeb, WI 53572 USA


Click Here to Send a Donation

Email admin@steelguitarforum.com for technical support.


BIAB Styles
Ray Price Shuffles for
Band-in-a-Box

by Jim Baron
HTTP