| Author |
Topic: Emmons 3-way toggle replacement |
John Poston
From:
Albuquerque, NM, USA
|
Posted 21 Aug 2014 8:34 am |
|
I was looking through some old threads about replacing the Emmons toggle switch and I was wondering if the one at the following link uses the same wiring schematic as the original:
http://www.elderly.com/accessories/items/EP075.htm |
|
|
|
Lynn Stafford
From:
Ridgefield, WA USA
|
Posted 21 Aug 2014 9:26 am Emmons 3-way toggle replacement
|
|
John,
That one will work but you'll need to modify the way the terminals are wired up. Here is an Emmons Schematic with a sketch I made that shows the way you'll need to hook up the wires and cap so it will work properly.
_________________
Best regards,
Lynn Stafford
STEEL GUITAR WEST
http://www.steelguitarwest.com
Steel Guitar Technician (Restoration, Set-up, Service and Repair work)
Previous Emmons Authorized Dealer & Service Technician (original factory is now closed)
ZumSteel Authorized Service Technician
---------------------------------- |
|
|
|
John Poston
From:
Albuquerque, NM, USA
|
Posted 21 Aug 2014 10:19 am
|
|
This is great.
Thanks so much, Lynn. |
|
|
|
Jim Bates
From:
Alvin, Texas, USA
|
Posted 22 Aug 2014 2:41 pm
|
|
Just replaced the one in my LeGrand. First I bought an exact replacement from Stewart MacDonald. Take a close up picture or two to show exact way of hooking up each wire and dressing the leads. Drawing is good but check several times to make sure it is correct before soldering.
(The old finally became intermittent at the wrong time,)
Thanx,
Jim |
|
|
|
