Lube Job for my Sho Bud
Posted: 27 Jan 2003 11:06 pm
What is the correct way to lubricate my Sho Bud Fingertip model? What lubricant and where should it be applied?
As to correct way? For the small, intricate places, I use a small hypodermic needle, i.e. an insulin needle maybe.
Lube? I use white lithium. Also have used a "teflon grease" that a friend gave me. Both work well. You just want something that's not going to dry out and gum up.
Where to lube? Any place where two pieces of metal rub against one another.
To lube the changer fingers, you have to tear down the mechanics of it all, take out the changers, drive out the large finger pins, and probably clean all of the assembly and the pins real good with solvent. Dry them. And then in putting the large pins back thru the holes of the changer fingers, make sure all of it is really lubricated well. Wipe off excess. This part is not an easy task. I know.
To work on a "Fingertip" it requires a whole lot of patience and some practical mechanical ability. About the time you think you can't do it, just remember: They put that baby together at the factory, it can also come apart and go back together again just like it went together back then! It's not rocket science. This may sound over simplified, but it's worked for me. Patience and time is your best ally. Also when in doubt or stumped, call Duane Marrs. He's a great friend of the steel guitar community and those of us who have worked on these babies. Especially the Sho-Bud's. Best regards, LBH
67 D-10 Sho-Bud Fingertip, 9x4, Ser 7 213 213,N'ville 400 Amp<FONT SIZE=1 COLOR="#8e236b"><p align=CENTER>[This message was edited by Larry Harlan on 28 January 2003 at 06:05 AM.]<FONT SIZE=1 COLOR="#8e236b"><p align=CENTER>[This message was edited by Larry Harlan on 28 January 2003 at 06:06 AM.]</p></FONT>