how to add pulls to knee lever

Ted Lowe Jr · Post by **Ted Lowe Jr** » 7 Jun 2014 6:18 pm

What parts do I need to add two pulls to an existing knee lever. It is an Msa vintage XL model and where can I order them? How hard is it to diy? Thanks

James Wolf · Post by **James Wolf** » 7 Jun 2014 6:40 pm

http://psgparts.com/MSA_c10.htm

James Wolf · Post by **James Wolf** » 7 Jun 2014 6:41 pm

http://psgparts.com/MSA_c10.htm

Lane Gray · Post by **Lane Gray** » 7 Jun 2014 7:37 pm

The hardest part is that, since they use round shafts, you have to remove the rear apron cover, loosen the existing bellcranks, slide out the shaft, and put it back in withthe added cranks. Other than that, it's pretty easy. I recommend MSA as the guitar to learn to tinker on.