Help...parts for 75 Fender Sho-Bud..?

Michael Dene · Post by **Michael Dene** » 29 Oct 2002 8:37 pm

My '75 Fender Artiste has broken one of the bell cranks, It's actually the one that "drives" the RKR change. I've managed to find a local engineer who is fabricating a new one out of mild steel, at a cost that need not be discussed here in case my children become even more worried about their inheritance!

My question for future reference is..Is there anywhere,within the industry,where parts are available for instruments that are out of production?

Michael

Andy Alford · Post by **Andy Alford** » 30 Oct 2002 8:38 am

Give Bob Simmons a call 205 647-2331.He reworked my Fender.It plays and stays in tune.[This message was edited by Andy Alford on 30 October 2002 at 08:39 AM.]

Peter · Post by **Peter** » 30 Oct 2002 11:26 am

I got my replacement from Al brisco. And I see that Bobbe Seymour has unbreakable ones in his store. Check the links.

------------------
Peter den Hartogh-Fender Artist S10-Remington U12-Hilton Volume Pedal-Gibson BR4 lapsteel-Guya "Stringmaster" Copy-MusicMan112RP-Peavy Rage158- - My Animation College in South Africa

Nick Reed · Post by **Nick Reed** » 1 Nov 2002 9:58 am

Michael, I had one of those guitars. Sho-Bud parts should be interchangable on it. . . since they built it in the first place. Back in the 70's Fender had a contact with Sho-Bud to build their Steel Guitars. Fender quit making their own when they went to using rods underneath instead of wire cables. NR

Joerg Hennig · Post by **Joerg Hennig** » 1 Nov 2002 10:03 am

As far as I know, a lot of parts on those guitars are interchangable with the SuperPro.

Michael Dene · Post by **Michael Dene** » 5 Nov 2002 12:10 am

Andy,Peter,Nick and Joe,

thanks for taking the time to reply. I've printed out a copy of this post to keep for such time as I may need it.(hopefully never!)

Michael