Excel Superb Rodding chart for C6 neck and bell crank holes

Mark Addeo · From: New Jersey, USA

Hello, I've been cleaning up a sorely abused lefty Excel Superb D10 pedal steel. The E9 neck was missing all the knees. These were all assigned to the C6 neck which had a very different copedant than the standard C6. I was able to get all the knee levers appropriately assigned back to the E9 neck and now it plays nicely with the standard E9 setup. Now I want to get the C6 neck going but it has required basically removing and moving all the bell cranks and re-rodding everything.

Before I get started I was hoping someone could share information on the appropriate bell crank holes for each rod. I can figure it out by feel but would be delighted to go right to a factory assignment. Any info would be helpful. All the best and happy New Year!

Forum Index > Pedal Steel		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: