The Steel Guitar Forum

If everyone keeps their shift a 800 on a nashville 400 what would that equate to on an ltd 400 in a clock setting??

------------------
JIM
"2000 Carter SD10" "73" MSA S10, "74" LTD 400, Profex II "55" Esquire, "63 Epiphone, "63" Precision,
"71" Jazz (The Bass)
REAL OLD STUFF

Jim,
I can't answer your specific question. I use a Session 400 from that vintage (late 70s) and I can tell you how I set it, but have no clue what the actual sweep range for the shift control is. Perhaps Mike Brown knows.

Whenever I eq any Peavey amp I usually start with all tone knobs at 12 o'clock. The bass usually ends up a bit above that and the treble a bit below. This is highly dependent on the ROOM and the GUITAR, so my numbers wouldn't do you much good. But I'd be willing to bet that 800 is somewhere near 12 o'clock. Once you have treble and bass set, listen carefully for what's missing or what's up too far -- does it need high mids? too muddy in the low mids? That's where you use the shift to home in on where and the mid control to increase or decrease at the frequency you homed in on. Make the changes small -- 1 or 2 notches can make a big difference.

Hope this helps some. I have never had any luck trying to eq an amp 'by the numbers'. The numbers are only good for one room, one guitar, and they change depending on how many people are in the room. Learn to HEAR your eq.

------------------
<small>Larry Bell - email: larry@larrybell.org - gigs - Home Page
2000 Fessenden S-12 8x8, 1969 Emmons S-12 6x6, 1971 Emmons D-10 9x9, 1971 Dobro

<FONT SIZE=1 COLOR="#8e236b"><p align=CENTER>[This message was edited by Larry Bell on 28 April 2002 at 08:06 AM.]</p></FONT>

I did a blind experiment comparing my 74 session 400 settings to a Nashville 400. I ended up with the knobs nearly identical in o'clock settings. The shift ended up around noon to 1 o'clock. I think the 800 is around 1 o'clock? Mid control usually around 8 or 9 o'clock.
(typo'd on the shift and mid) Corrected now! <FONT SIZE=1 COLOR="#8e236b"><p align=CENTER>[This message was edited by Dennis Detweiler on 28 April 2002 at 02:03 PM.]</p></FONT>

Jim , I have a 1976 session 400 and the shift knob is calibrated 1 thru 10..Its setting beside a Nashville 1000 and I switch between the two...

The knob positions wide up the same with the 1000 at 800hz and the 400 at 1 -2 o'clock..

------------------
Jerry Wallace-2001 Zum: D-10,8+6, "98 Zum: D-10,8+8,Nashville 1000,Session 500 ,Session 400 head only amp,Tubefex,ProfexII, Artesia, New Mexico
http://communities.msn.com/jerrywallacemusic http://www.jerrywallacemusic.com

Thanks all this has helped a lot!!

this thread can be closed thanks

------------------
JIM
"Carter SD10" "73" MSA S10, "74" LTD & NASHVILLE 400, Profex II "55" Esquire, "63 Epiphone, "63" Precision,
"71" Jazz

Jim, is that AM or PM ?

Moved to 'Electronics' section.