help with Sho-Bud Mechanism
Posted: 26 Apr 2002 6:16 pm
I now have a Sho-Bud steel that used to be a D10 but is now a single neck with a pad where the C6th used to be. I am not familiar with the set up that exists nor do I want to be. I'd like to try the standard E9th I got off Bob's page. The problem is I'd like to get some info on the mechanism before I start cranking the allen wrench. Do some of the screws raise and some lower? Any help will be greatly appreciated. Texas Jack Baker <texjac@netins.net>
------------------
Texas Jack
------------------
Texas Jack