Custom Pak- A- Seat

Ronald Sikes · From: Corsicana, Tx

I had Dan Rollans with Pak A Seat build me a custom seat to mount a Furman voltage regulator in . With just a few phone calls and a couple of pics this is how it turned out.As you can see it turned out very,very nice.I use a Session 2000 a lot and really needed the protection of the VR,it's more than just a power conditioner it maintains a constant voltage,so I wanted to cut down on carrying the extra rack mount and came up with this idea,and Dan did an excellent job on it .

[This message was edited by Ronald Sikes on 19 December 2006 at 08:40 PM.]

Danny Hullihen · From: Harrison, Michigan

That looks great Ron and definately good thinking when you're using digital equipment such as the Session 2000. Thos units are a little pricey, but well worth the expense when you consider what you're saving in the long run.

Dan did a great job (as always) with the mounting of that unit in the seat!

Forum Index > Upcoming Event Announcements		Next oldest topic :: Next newest topic

All times are GMT - 8 Hours	Jump to: