| Author |
Topic: Face plate for Fender Twin |
Len Amaral
From:
Rehoboth,MA 02769
|
Posted 8 Nov 2012 9:12 pm |
|
Does anyone know where I could get a custom face plate where the poteniometers go through for a Fender Twin?
I came across a good project amp to completely restore but could use a new face plate.
Thanks,
Lenny |
|
|
|
Stephen Cowell
From:
Round Rock, Texas, USA
|
|
|
|
Ken Fox
From:
Nashville GA USA
|
Posted 9 Nov 2012 5:32 am
|
|
| Fender shut down all the U.S. makers of reproduction plates a few years back. I still use an off shore company that you will see on eBay selling chassis kits. I have used Song Wut for over ten years for Blackface Plates and chassis. A real perfectionist for sure. I will PM his email address to you. If it is a Blackface plate you need you won't do any better than him for sure. No one I know has Silverface plates anymore. I used to use a guy in Oklahamo for those, his were perfect. Fender shut him down as well. |
|
|
|
Len Amaral
From:
Rehoboth,MA 02769
|
Posted 9 Nov 2012 9:01 pm
|
|
Thanks for all the info on faceplates. This will be a great help working on this project.
Thanks,
Lenny |
|
|
|
Bob Metzger
From:
Waltham (Boston), MA, USA
|
Posted 14 Nov 2012 11:59 am Fender Twin Reverb faceplate...
|
|
I might have an original silverface Twin Reverb faceplate, used. I don't have any blackface ones. Let me know if you're interested in a used silverface one.
Bob M.
_________________
Bob M. |
|
|
|
Bob Metzger
From:
Waltham (Boston), MA, USA
|
Posted 14 Nov 2012 12:00 pm Fender Twin Reverb faceplate...
|
|
I might have an original silverface Twin Reverb faceplate, used. I don't have any blackface ones. Let me know if you're interested in a used silverface one.
Bob M.
_________________
Bob M. |
|
|
|
Len Amaral
From:
Rehoboth,MA 02769
|
Posted 14 Nov 2012 12:23 pm
|
|
Hey guys:
I am out of Mass until Nov. 30 but did put a deposit down on what looks to be a sweet original 65 Twin that has been sittng for years and looks almost new. I know I will have it gone through and recapped and tubed or anything it needs but it is the real thing.
Still buying gear after a 1/2 century  |
|
|
|
Bob Metzger
From:
Waltham (Boston), MA, USA
|
Posted 14 Nov 2012 12:32 pm
|
|
Len,
Get a hold of me if you need someone to service this amp for you. This is right up my alley and I'm nearby.
Bob M.
_________________
Bob M. |
|
|
|
Jerry Fleming
From:
Roanoke, Virginia, USA
|
Posted 14 Nov 2012 2:07 pm
|
|
Lenny,
Send me an email or PM. I may be able to help with your faceplate.
Kind regards,
Jerry |
|
|
|
