| Author |
Topic: emmons pickup installation help needed |
Philip Mitrakos
From:
The Beach South East Florida
|
Posted 25 Aug 2012 5:00 am |
|
I'd like to get some help or photo on how these emmons pickups are mounted ...
I have not yet pulled my truetones out to see the mounting plates..to see if I need to make mounting plates or what? ?
Thanks phil. pittsburghphil@hotmail.com
 |
|
|
|
Stephen Cowell
From:
Round Rock, Texas, USA
|
Posted 25 Aug 2012 5:55 am
|
|
Looks like soap-bar mounting to me... you put a piece of foam under the pickup and use four wood screws to 'float' the pickup on the foam. I can't see any other way of mounting them without another bracket or something.
_________________
Too much junk to list... always getting more. |
|
|
|
Philip Mitrakos
From:
The Beach South East Florida
|
Posted 25 Aug 2012 7:17 am
|
|
Im going to install these in this guitar
 |
|
|
|
James Marlowe
From:
Florida, USA
|
Posted 25 Aug 2012 10:09 am
|
|
Philip,
I had one in my Zum I had to drill and tap the four holes. Emmons supplies those screws (good luck with that one), but Fastenal carries them too. I forget what the size is, but it tells you on the Emmons website. I suggest using stainless screws, since they go right through the middle of the p'up near the poles.
_________________
J.R. Marlowe
Life has many choices. Eternity has TWO. I choose Heaven.
Black '95 Zumsteel SD10, 4+5;Black Mullen RP SD10, 4+5
NRA Life member |
|
|
|
Lynn Stafford
From:
Ridgefield, WA USA
|
Posted 25 Aug 2012 11:21 am Pickup Mounting Screws
|
|
Phillip,
You'll need to remove the mounting plates so you can drill and tap them for the very small 2-56 mounting screws (item G) on page 7 of the Emmons Catalog.
If you look at the mounting plate (item J) also shown, you'll see the smaller 4 hole bolt pattern that's used for these pickups.
_________________
Best regards,
Lynn Stafford
STEEL GUITAR WEST
http://www.steelguitarwest.com
Steel Guitar Technician (Restoration, Set-up, Service and Repair work)
Previous Emmons Authorized Dealer & Service Technician (original factory is now closed)
ZumSteel Authorized Service Technician
---------------------------------- |
|
|
|
Philip Mitrakos
From:
The Beach South East Florida
|
Posted 25 Aug 2012 4:55 pm
|
|
| Thank you got it! |
|
|
|
Jan Mulder
From:
The Netherlands
|
Posted 30 Aug 2012 5:26 am
|
|
Make sure you don't use metal screws, only brass or RVS screws!
Jan |
|
|
|
Larry Moore
From:
Hampton, Ga. USA
|
Posted 30 Aug 2012 5:25 pm mounting the 108-n
|
|
You can get the screws from Emmons about $0.25 ea
they are non magnete. I have them on mine no problem
The Emmons mounting plate has the holes 4-40 threads per in.
Larry |
|
|
|
