Page 1 of 1
Stereo Steel Preamp and Nasvhille 400 connection question
Posted: 11 Dec 2011 12:49 am
by Joseph Borja
I wanna just use the SS and speaker of the Nashville and bypass the amp electronics. Is there a way to do this without rewiring or having to tear into the amp head?
Posted: 11 Dec 2011 6:51 am
by David Higginbotham
Yes, just run a cord from the SS to the "preamp in" jack on the rear of the NV400. This will bypass the preamp section of the NV400.
Posted: 11 Dec 2011 8:52 am
by Lane Gray
You misspelled "Power Amp In," but that's exactly correct
Posted: 11 Dec 2011 10:55 am
by David Higginbotham
Thanks for the correction Lane. I haven't owned a nv400 in years and forgot the exact wording on the rear of the amp...
Posted: 11 Dec 2011 11:55 am
by Joseph Borja
ok, so SS into power amp? Thanks for replies, been experimenting with different setups and didn't wanna mess up any of the gear.
Posted: 11 Dec 2011 2:44 pm
by Jerry Overstreet
I'll tell you what I used to do when I had a Walker SS combo.
When traveling to regional steel shows where NV400's were provided, I would use a Y cable from the headphone jack of the SS and run the mono ends to the pwr. amp ins of the 2 400's for a stereo connection. This gives you all your front end and whatever fx you have in line to your preamp.
I talked to GD Walker about this and he agreed that it would work OK. He also gave me another routing, but I've forgotten what it is.
You can always call him for advice. He's always willing to help and talk steel.