Page 1 of 1
Looking for a solid single ten end plate
Posted: 10 Apr 2011 12:00 pm
by Paul Adams
Does anyone have a junk solid endplate for sale. Don't want to spend a bunch of money on this, just experimenting. Brand is not important as long as it's the solid end. Thanks, Paul
Posted: 11 Apr 2011 2:32 pm
by Paul Norman
Linkon steel guitars. In Canada has these finished and unfinished. The finished ones are expensive, but the the raw one needs a lot of sanding and polishing. I dont know if you want to go to all that finishing.
If not: An aluminum machine shop may make you one if you give him all the specs.
end plate
Posted: 12 Apr 2011 2:12 am
by Paul Adams
Thanks Paul. I was just looking around for a junk one. Perhaps one that had the leg wholes all stripped out. I'll look into it. Thanks for your thoughts!